
Partial and full chimney rebuilds — from the roofline up or from the ground — when repair is no longer the honest answer.
Some chimneys reach the point where patching stops making sense: mortar gone through the whole stack, brick spalling on every face, a lean you can see from the street. A rebuild takes the failed masonry down to sound structure and builds it back — new brick, new mortar, new crown, new flashing, and a flue that passes a camera inspection when we are done.
Most New Jersey rebuilds are partial: from the roofline up, where weather does its damage, while the stack below the roof is still sound. Full rebuilds are for chimneys failing along their whole height or leaning. We photograph the condition, explain which category yours is in, and quote the job in writing — brick matched to your home as closely as modern materials allow.
Tell us about your chimney or gas fireplace — we confirm every request by phone. Prefer to talk? Call (855) 424-6217.
Above the roof, a chimney lives outdoors in every direction — rain, sun, freeze-thaw and Shore salt all attack the same few feet of masonry. Below the roofline the stack is sheltered and often perfectly sound. A roofline-up rebuild replaces exactly the part that failed: we take it down to the flashing line, rebuild with fresh brick and mortar, pour a proper crown, and reflash. The result looks new because it is new, and it resets the clock for decades.
A chimney that leans, bulges, or has mortar failure from the ground to the top cannot be saved by repointing — the structure itself is done. Full rebuilds are bigger projects with scaffolding and a longer timeline, and we will not recommend one unless the evidence demands it. When it does, doing it once and correctly is cheaper than a decade of patches on a failing stack.
Most are completed in two to four days depending on height and access, weather permitting.
We source brick to match size and color as closely as current manufacturing allows and show you samples before we start. On older homes a near-match is typical; exact matches for discontinued brick are not always possible, and we will tell you upfront.
If the camera shows liner damage, rebuilding is the cheapest moment to address it — the chimney is already open. We inspect and advise before teardown begins.
Yes — new flashing is part of every rebuild, woven into the shingles correctly. Rebuilding a chimney and reusing failed flashing would undo the point of the job.
A full sweep of the flue, firebox and smoke chamber — creosote gone, draft restored, and a written condition report before we leave.
Learn more →
Level 1 and Level 2 chimney inspections with camera scanning, a photo report and straight answers — for annual checks, home sales and after a chimney fire.
Learn more →
The annual inspection for chimneys in regular service: every accessible part checked, condition documented, safety confirmed for another season.
Learn more →
Camera inspection of the entire flue, plus attics, crawl spaces and concealed areas — the inspection for home sales, chimney fires and appliance changes.
Learn more →